Retro-Reflective Performance
V-REFLEXTM Reflective Material - Flame Resistant (Fluorescent Lime-Yellow and Fluorescent Red-Orange) High Visible Industrial Wash Heat Transfer Reflective Tape exceeds the minimum retro-reflective requirements of EN ISO 20471, ANSI/ISEA 107 Level 2 (and other norms that are inherent from them), when tested at e = 0° or e = 90° in accordance with the procedures stated on standards.
Minimum coefficients of retro-reflection required by standards are shown as below table. (Coefficient of Retro-reflection * (R' or RA ) cd/lux/m2)
|
Observation Angle |
Entrance Angle (β1, β2=0) |
|||
|
5° |
20° |
30° |
40° |
|
|
0,20°(12') |
65 |
50 |
20 |
5 |
|
0,33°(20') |
25 |
20 |
5 |
1.75 |
|
1,00°(1°) |
5 |
4 |
3 |
1 |
|
1,50°(1°30') |
1.5 |
1 |
1 |
0.5 |
Measured on new product at +5.0° entrance and 0.2° observation angles, silver reflective part in the middle of tape typically has retro reflective performance as below table.
|
Initial Average RA |
Minimum RA |
|
500 |
65 |